Haloview Backup Camera
Have the camera installed and it works pretty well except I can not get more than two bars. I have two auxiliary antenna, one for the camera mounted on the back of the trailer, the other for the monitor inside the truck. Still only two bars. I suspect the problem may be with my trailer. I have a 32 foot Springdale hitch pull. It has aluminum siding and a bunch of stuff on top as well as a slide canopy that may be interfering with the signal. Any suggestions on how to boost reception?
Is the only problem not getting more than 2 bars displayed or does it actually have cutouts and distortions in the picture? Sometimes the little bars aren't that accurate. Mine stays at 3 bars sometimes dropping to 2 bars but the video signal is solid
Also, I have heard other devices can cause interference, even the fancy electronics that many modern trucks have.
Same here, I get 2 to 3 bars. Picture is of high quality.
So I do like I do for my black tank sensors. I ignore the bars..
Thanks for the quick reply. Yes, my picture is solid with little or no distortion. I'll treat this like I did with an old car I once owned, The check engine light would not go out regardless of what I did. I finally cut a small square of black tape and pasted it over the engine icon. Problem solved! Thanks, Ray and GeekGuy!
Sign in or register to add a comment.
Add a Comment
Welcome to the Love Your RV! Community Forum
Ask For Help
Tales From the Road
RV Park Reviews
RV Tips & Tricks
Mods, Repairs & Upgrades
RV Product Reviews
Haloview RD7 Wireless Rear View Camera Kit (Extended Range)
Haloview Wireless RV Rear View Camera Review
Reolink Go 4G Mobile Security Camera Review
DIY RV Security Camera
Support the Forum
Terms of Service
Created with PlushForums
© 2020 Love Your RV! Forum