RV Power/Tow Cable Tip – Fix Pulled Away Cord Covering
Here is a quick little tip for repairing a power or tow cable where the outside jacket is slowly pulling away from the plug.
Fellow full-time RVers Greg and
clued me into this repair. First, you heat up the cord either by leaving it in the sun or with a heat gun. Next, add some brown Gorilla Glue or another similar adhesive (I used G/Flex Epoxy) to the end near the connector.
Then slowly pull on the cord, working the cover toward the plug end. Eventually, enough cord material will shift forward and back into the plug. The glue or epoxy will seal it in place, preventing the problem from happening again.
Cracked Waste Tank Repair -
Broken Show Head Holder Repair -
RV Power Plug Conversion -
Just out of curiosity ; any reason you just didn't take a couple of wraps with electrical tape and then use your epoxy?
I actually had taped it before and over time it still slowly pulled away. I think the trick is to get the existing covering back into the plug head where it starts out when new along with some glue so it seals in there and doesn't pull out again. Other cords I've used have a physical clamp inside the plug, but these are molded together so can't open. Could have always cut the cord and added a new plug but this was simple to do.
For my 30a. shore cord I just replaced the plug. Incidentally, I found a very good quality replacement. It has chromed-type lugs that seem to dissipate heat much better than the original brass ones did.
Sign in or register to add a comment.
Add a Comment
Welcome to the LYRV Forum
Click for Invite Information
Ask For Help
Tales From the Road
RV Park Reviews
RV Tips & Tricks
Mods, Repairs & Upgrades
RV Product Reviews
Replacing 7 Pin RV Type Tow Cable Assembly
7 Pin Tow Cable Charging Tests using Lithium RV Batteries
Replacing the RV Shower Faucets - Dura Faucet DF-SA100
Plumbing a Mr. Heater Big Buddy Heater into your RV propane system
Support the Forum
Terms of Service
Created with PlushForums
© 2022 Love Your RV! Forum