Tekonsha P3 brake controller problem?
I have a Tekonsha P3, which is 5 years old. There is no tech support from Tekonsha with out an account or proof of purchase. Since I’m 63, I don’t remember who I purchased it from or where the receipt is? I'm doing good keeping last week straight.
I set it for no boost and 12 volts for braking. Input is 14.3 volts, output using the manual lever is 11.9 volts and 5.9 amps, BUT, when applying the brake pedal, it’s less than 2 volts and a few tenths of an amp.
Why is there a difference in voltage between the manual lever and applying the brake pedal? I believe the problem is inside brake controller?
When using the manual lever, I hear a click which sounds like a relay to me. No click when the inertia sensor is activating. I’m thinking there is a problem with the switch that is utilized by the inertia sensor?
The P3 has preformed very well and been reliable in the past.
Any help would be much appreciated.
"Please accept the comment that answers your question.
I have no idea why this appeared?
Are you testing it while just parked or are you testing it while braking the trailer pretty hard? Just parked it will show a low voltage output with the pedal versus the manual override since it's designed to output power as needed. Like during a panic stop it would be full voltage.
The "Please accept the comment that answers your question" is because this is the Ask for Help category so has a special question mode, that way later on people can see easily the right answer. Cheers, Ray
What does the "Question" option do?
Question mode lets the original poster (or a moderator) identify the definitive answer to a question. This is ideal for customer service or building a knowledge base.
Thanks for the prompt reply Ray.
The P3 is a proportional controller so I have been testing it at around 45 mph on our country road here. We have 4" of snow foretasted here tomorrow in NE Wisconsin. I'm going to pull the controller out today and tinker on it tomorrow. The more I think about, I suspect the inertia sensor more than what is utilized to do the actual switching on the circuit board. We shall see.
And, thanks for the retro movies. I didn't know you had two of those beagles. It was good to see Anne well and enjoying herself.
You two take care and maybe we could share a couple of pints sometime at the American girl mind area? Cory
Sign in or register to add a comment.
Add a Comment
Welcome to the LYRV Forum
Click for Invite Information
Ask For Help
Tales From the Road
RV Park Reviews
RV Tips & Tricks
Mods, Repairs & Upgrades
RV Product Reviews
ROVER LI 20 AMP MPPT or 40 AMP MPPT SOLAR CHARGE CONTROLLER
Testing out a Cheap 40A MPPT Solar Charge Controller
Checking Out a New BougeRV 40A MPPT Solar Controller with Bluetooth App
Charge Controller/Inverter-Charger/Monitor Brands
Support the Forum
Terms of Service
Created with PlushForums
© 2022 Love Your RV! Forum