Russell Nesbitt - Uploads

My Norcold fridge is getting an error code "LI op", the high temp cut of switch shut off. The alarm goes off and then it will reset itself for a while. Sometimes it will work for hours and others just a few minutes.

I see all kinds of videos about how to reset it with magnets, however mine seems to reset itself when I turn it off for a few minutes.

I noticed that if I bump a brown wire from the switch (which leads to the thermostat), can turn the alarm on and the light comes on.

Check out my photo of the thermostat, is this in the correct place? It seems like it should be more inside the housing.

Also, I am running the fridge on AC (via my batteries) and the pipe that the switch is connected to is very hot to the touch (around 125 degrees). Should that be that hot?

Any ideas will be helpful.

Thanks.